Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterLinear Gate Repair in Highland Park: What to Know First
Linear gate repair in Highland Park typically runs $185 to $485 depending on whether it’s a control board, a limit switch, or a hinge post that’s given up. Most Linear jobs at Gatewood Fence & Gate are done same day or next morning because we keep common Linear boards and sensors on the truck and we weld on site instead of hauling your gate to a shop. We’re an independent Linear service provider, not a factory warranty center, which means we tell you straight when a board is worth fixing versus when you’re better off putting that money toward a new opener. If you’re reading this because your Linear gate is beeping, half-opening, or not responding to the remote, call (325) 936-1371 and tell us what it’s doing wrong. You’ll get a real person on the line, not a recording, and that person is usually the guy who’ll be standing in your driveway.
How Linear Products Fail and How We Fix Them
Linear has been around the Dallas gate market for decades, which means the stuff showing up in Highland Park driveways is rarely new. That adds a few failure patterns you won’t see in a factory brochure:
- Linear APeX and LRA series control boards burn out their relay contacts. The board looks fine from the outside, but the gate will only move when you hold the remote button down or it’ll open and refuse to close. That’s the relay, not the motor. We test the board first, replace the relay or the board only if the relay is surface-mount, and you don’t pay for a motor you never needed. Highland Park’s summer heat makes this worse because the boards run hot inside powder-coated steel cabinets that face the afternoon sun.
- Linear actuator-driven gates (the ALC and LA400-style models) kill their limit switches when the gate sags even a little. The actuator is strong enough to push the gate, but the switch keeps getting told to stop in the wrong place, so it cycles and fails. We realign the gate first, then replace the switch. Skip the realignment and you’ll replace that switch again in six months.
- Linear BlockBuster photo eyes fail on sun glare and spider webs before they fail electrically. Anyone who’s had a Highland Park driveway gate stop six inches from closing and stare at them knows this one. The eyes are set across the opening, and the Texas afternoon sun hits them at exactly the angle that makes them think something’s in the path. We relocate the receiving eye or add a hood, which costs about an hour of labor, versus a factory tech who wants to sell you a new pair of eyes.
- Linear MDR and MDRRG swing operators leak at the top cover seam on the older gray-box units. Water gets in, drips onto the capacitor, and the operator hums but won’t start. We dry the unit out, replace the capacitor, and reseal the seam with the same kind of gasket material you’d use on a boat hatch. That fix usually runs under $200 and buys you another few years.
- Hinge and post problems on Linear swing gates wear out the operator before the operator fails. A Linear swing operator is strong enough to pull a sagging gate, but only by doing damage to itself. When we find an operator with a dead gearbox, we always check the hinge post. Most of the time the post has shifted a half inch in the clay soil, and unless we reset it, the new operator inherits the same fight.
Our Linear Gate Repair Process
Here’s what a Linear repair looks like when we show up at a house in Highland Park:
- 1
You call, a person answers. Tell us the symptom, the brand, and roughly how old the operator is. We’ll tell you honestly if it sounds like a board, a hinge, or something we need to see in person.
- 2
We show up and we diagnose in your driveway. We bring a stocked truck, and we test the board, the limits, the eyes, the actuator or swing arm, and the hinges. I grew up about a mile from the Katy Trail corridor and I’ve been doing this since 2001, so most Linear failures are something I’ve seen before.
- 3
You get the price before we touch a tool. We give you the number for the repair, and that number doesn’t change at the door. If the job needs to go over $200, we knock $40 off before we write it up.
- 4
We use OEM Linear parts when they matter and quality aftermarket parts when the OEM part is overpriced for what it is. A factory Linear board costs what it costs, but a capacitor, an eye hood, or a hinge doesn’t need a Linear stamp on it to last. We’ll tell you which is which and let you decide.
- 5
We weld on site. If your hinge post has moved or the gate frame has cracked at a weld seam, the repair happens in your driveway. We don’t load your gate onto a trailer unless there’s no other way.
- 6
We test it hard and we hand you our 90-Day Done Right Promise in writing. If it’s not done right, one call brings us back. No runaround.
What Linear Gate Repair Costs in Highland Park
Here’s what we see on Linear work around Highland Park, and what moves the number:
| Repair scenario | Typical range |
|---|---|
| Photo eye realignment, hood, or cleaning | $85-$150 |
| Capacitor replacement on an older Linear operator | $140-$200 |
| Limit switch replacement and gate realignment | $185-$285 |
| Control board replacement (Linear APeX or LRA) | $295-$485 |
| Hinge post reset with on-site welding | $350-$600 |
What moves the price is whether the board is a current model or a twenty-year-old unit that’s only available used, how far the post has moved, and whether the gate itself has frame rot from years of standing water at the bottom rail. You’ll hear the number before we start. You’ll get the same number at the end. Call (325) 936-1371 for a free estimate, and remember there’s no trip charge if you’re inside the county.
Why Highland Park Homeowners Call Gatewood Fence & Gate for Linear Work
Hal Gatewood’s name is on the shop, and the shop is down the road. That’s the oldest accountability there is. We’ve been working on gates in and around Highland Park since 2001, long enough to have worked on the same driveway gate twice for the same family, and long enough to know which Linear units hold up and which ones were built to a price point. We’re certified to service nine major gate brands, including Linear, LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, so when we tell you a Linear actuator has one more year in it or it’s done, we’re comparing it against everything else we see on the road. We answer the phone 24/7 with a live person. We show up in a window you can plan your afternoon around. And every job leaves with the 90-Day Done Right Promise in writing, because if it’s not done right, we’re coming back anyway. You shouldn’t have to ask.
FAQs
If the operator is still under the manufacturer’s warranty, we’ll tell you before we start so you can decide whether to call the factory service channel instead. On most Highland Park Linear gates, the warranty expired years ago and the question is moot, but we never touch something under warranty without putting that choice in your hands first.
Most common Linear boards, sensors, and capacitors are on the truck when we arrive. If we need something unusual, we’ll give you a straight answer on what it costs and how many days it’ll take, and we won’t pretend it’s overnight if we know it’s not.
Sometimes. If the board or capacitor is the only problem and the rest of the unit is dry and tight, we’ll tell you to keep it. If the gearbox is going and the gate is heavy and the hinge post is moving, you’re likely better off putting repair money toward a new operator. We’ll show you both numbers and let you decide.
In most cases, same day if you call before noon and the job is a board, eye, or limit switch. If it’s a hinge post or weld repair, we’ll give you a window and we’ll hit it. Call (325) 936-1371 and tell us what it’s doing wrong; we’ll tell you when we can be there.
We service LiftMaster, Mighty Mule, Ghost Controls, DoorKing, and the rest of the nine brands we’re certified on, so the same crew that repairs your Linear today can install a different brand tomorrow if you ever go that route.
Call Gatewood Fence & Gate for Linear Gate Repair in Highland Park
Tell me what it’s doing wrong and I’ll come take a look. You’ll get a free estimate, no trip charge inside the county, and a 90-Day Promise in writing when we’re done. Call (325) 936-1371.
Written by Hal Gatewood, Owner, Gatewood Fence & Gate at Gatewood Fence & Gate, serving Highland Park and nearby areas.